
5
RJ31X Jack
DB-6 Cord
To control panel
phone jack.
Red
Green
Gray
Brown
Cable run
by installer.
Tip (+)
Ring (-)
Green
Red
Red
Red
Red
Green
Green
Green
Black
White
(or Yellow)
Black
White
(or Yellow)
Red
Green
Lines from
phone jacks
on premises.
TELCO Block
Installation Guidelines
It is recommended that you install new systems in
the following order:
>
Run the required system wiring (phone line
for RJ31X jack).
>
Mount the control panel.
>
Power up control panel and clear memory.
>
Program alphanumeric keypad into the
control panel.
>
Program system parameters.
>
Program detectors into the control panel
and test them.
>
Mount detectors.
>
Exit programming mode.
Note: Detector programming and testing are done in one
step. When a device is programmed into the control panel,
the alphanumeric keypad displays a message automatically
prompting you to test the device.
When installing this security system, it is recommended
that you rst run the phone line for the RJ31X jack to the con-
trol panel location. This is the only wiring requirement
for this system.
Running The Required
System Wiring
The only system wiring requirement is for a phone line
connection. This line should be run before any power up or
programming procedures.
Installing an RJ31X Jack
Systems set up for central station monitoring, Email, and/or
voice messaging require that the control panel be connected
to the phone line.
It is especially important that monitored systems be
connected to the phone line with full line seizure using an
RJ31X jack. This type of connection places the control panel
ahead of all other devices connected to the phone line. This
ensures that the control panel has the priority to seize the
phone line and cut off all other phone devices in the event
of an alarm, even if the line is in use.
2. STOP. Do not connect the DB-6 plug to the control panel
phone jack at this time. You will be instructed to do this only
after all programming is completed and successful.
Phone Line ConnectionsInstallation Planning
1. Install the RJ31X jack for full line seizure as described in
the following diagram.
Vid eofied Security System I nstallatio n Manual
Comentários a estes Manuais